T18-0.75DCT4

750W Turgo Turbine Generator

T18-0.75DCT4 is a AC direct systems consist of a turbine-generator unit producing AC power which is used as needed. That is, it is fed directly to the appliances. No need of battery and inverter, T18-0.75DCT4 offers a complete water to wire system with integral turgo turbine, generator and valve flow control. Designed to deliver ready-to-use 115V/230V VAC power, it employs a brushless, special rare-earth permanent magnet alternator and therefore has a higher efficiency than ordinary alternator. Output voltage and frequency are controlled by the electronic load controller(with ballast). As little as 6 to 8 liter(30 gallon) per second (l/s) falling 18 meter through a pipe can supply enough power to comfortably run a small household. This machine is compact, easy to install and requires little maintenance except lubricating the bearing every few months.

The turgo turbine was designed for families in remote areas to produce power for their households easily and inexpensively. These units have been incredibly successful and today thousands are installed throughout the world.

These turbines need very little water flow to run efficiently and produce significant power out. The standard configuration uses one nozzle

Water is collected upstream from the turbine and channeled in a pipe down to the turbine location. At the turbine, the water passes through a nozzle, where it accelerates, strike the turbine runner, and turn a AC single-phase brushless permanent magnet alternator. A electric load controller is built on the alternator which stabilizes the voltage to 110V or 220V to protect electrical appliances during use. Installation is very simple and explained in the manual. Once installed there are no running costs and maintenance costs are very low.

Item	Parameters
Model	T18-0.75DCT4
Water Head Range	14 – 18 meter(46 – 59 feet)
Water Pressure	26 PSI
Water Flow Range	5 – 8 liter(1.3 – 2.1 gallon)/second
Rated Power Output	750W
Intended voltage	115/230V~
Rotary Speed	1500 rpm
Turbine runner type	Turgo
Runner diameter	150
Number of buckets	12
Number of nozzles	1
Jet diameter	75 mm
Generator	Single phase permanent magnet alternator
Power factor	1.0
Insulation level	B/B
Protection level	IP44
Temperature	-20°C~50°C
Humidity	≤90%
Safety protection	Short circuit, over load, Islanding, Grounding fault
Packing material	Fiberboard
Packing size	38 x 34 x 42 cm
Gross weight	28 kg

Turbine Generator

OUTPUT IN WATTS against various head and flow
Water head (meter)	Water flow(liter/second)
Water head (meter)	5 liter/sec	6 liter/sec	7 liter/sec	8 liter/sec
10	150W	300W	350W	440W
11	165W	330W	385W	484W
12	180W	360W	420W	528W
13	195W	390W	455W	572W
14	210W	420W	490W	616W
15	225W	450W	525W	660W
16	240W	480W	560W	700W
17	255W	510W	595W	700W
18	270W	540W	630W	700W

If you feel you may have a suitable site, please email specific information on your actual site. The information that is required for a preliminary assessment is:
1. The volume of water flowing in your stream, expressed as liters per second.
2. The head (height of drop) of the falling water, expressed in meters.
3. The length of the penstock (pipeline) in meters.